Dazon Raider Extreme 1100D Service Manual download pdf (Page 48)

Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005

d) Inspect if the start button is conductive; at this time, remove the starting relay inlet line (the

green/yellow line.

e) Connect the yellow/red line with the ground wire, and press the start button. It should be

conductive between the yellow/red line and the ground wire; otherwise the start button, its wire,

or the wire connector is not good.

e) Inspect the working condition of the starting relay; at this time, remove the starting relay.

g) Connect the C end and the D end of the starting relay with the battery, and the A and B end with

the millimeter.

At this time the millimeter should indicate the conductive condition; otherwise, the starting relay

is not good.

3.19 Belt Driven CVT Mechanism

3.19.1 General Introduction

The belt driven CVT mechanism is made up of two belt pulleys (the drive belt pulley and the

driven belt pulley) whose diameter can be changed, and a notched driven belt. The driving belt

pulley is mounted on the engine crankshaft, and the driven belt pulley connects with the rear

driven mechanism.

Its basic operational principle is to realize the automatic CVT by the diameter changes (the

transmission ratio changes) of the driving and driven belt pulley.

 The batter

volta

e should be at 12 volts.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 78 79

No comments

Dazon Raider Extreme 1100D Service Manual Page 48