Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005
44
d) Apply oil on the O-ring, and install the starter motor;
Tighten the holding bolts.
3.17 Reduction Mechanism
3.17.1 General Information
The picture shows the structure of the reduction mechanism.
1. Starter reduction gear 11. Clamp
2. Starter reduction gear shaft 12, 21. Bolt
3. Starting clutch gear comp. 13. Nut
4. Starting clutch outer comp. 14. Washer
5. Flange starting clutch 15. Dowel pin
6. Starting clutch roller spring 16. Key woodruff
7. Spring holder 17. Roller
8. Starter motor 18. Needle bearing
9. Starter motor lead wire 19. O-ring
Make sure the starter motor case is free of metal particles, because it is
magnetic.
Before installing the starter motor on the vehicle after assembling it, firs
connect the lead wires and inspect if the motor runs normally.
Comments to this Manuals