Dazon Raider Extreme 1100D Service Manual download pdf (Page 18)

Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005

3.2.3 Inspection of Connecting Rod End

a) Put the piston ring and bearing into the connecting rod end; inspect the tightness degree of the

piston pin in connecting rod end.

b) Measure the inner diameter of the connecting rod end.

Service limit 15.06 mm

c) When the abrasion of the bore exceeds the limitation, it should be replaced.

3.2.4 Piston Ring Set

Before setting up, apply some oil on every piston ring, and then enlarge the piston rings. AT the

same time, cover them on the piston and move forwards gradually until the piston rings fall into the

ring groove.

3.2.5 Installation of Piston Ring

a) Remove the gasket attached to the crankcase.

b) Mount the piston onto the small end of the connecting rod.

c) Mount the piston pin and piston pin clip.

 The top of the piston with “IN” mark should be mounted towards the direction of the

inlet port (If the mark is “EX”, it should be mounted towards the direction of the

exhaust port.)

 Apply some oil on the piston pin to lubricate it.

 Cover a piece of cloth on the crankcase port to avoid the piston pin clip from dropping

into the crankcase.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 78 79

No comments

Dazon Raider Extreme 1100D Service Manual Page 18